Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
vms:ipfire [2015/03/31 19:25] admin [Start the VM] |
vms:ipfire [2015/03/31 19:28] (current) admin [Start the VM] |
||
---|---|---|---|
Line 115: | Line 115: | ||
> reboot | > reboot | ||
</code> | </code> | ||
- | |||
- | It will boot, do some housekeeping and reboot. During the reboot you will lose your console, and must reconnect. | ||
Start the virtual with | Start the virtual with | ||
Line 124: | Line 122: | ||
</code> | </code> | ||
- | the -c tells xl to connect you to the console immediately. You can watch as the housekeeping is done (mainly, enlarging the / partition), then you will see the reboot message. When you are back at the DOM0 prompt, reconnect with | + | It will boot, do some housekeeping and reboot. During the reboot you will lose your console, and must reconnect. |
- | xl console ipfire | + | the -c tells xl to connect you to the console immediately. You can watch as the housekeeping is done (mainly, enlarging the / partition), then you will see the reboot message. When you are back at the DOM0 prompt, reconnect with |
+ | <code> | ||
+ | > xl console ipfire | ||
+ | </code> | ||
- | and configure your router. Remember, if you are connected over a terminal window on your workstation (likely via ssh), the size of the window should be as close as possible to 80 char x 24 lines. This is an ongoing issue with the scon install, and one that can not be easily fixed. | + | Then configure the router. Remember, if you are connected over a terminal window on your workstation (likely via ssh), the size of the window should be as close as possible to 80 char x 24 lines. This is an ongoing issue with the scon install, and one that can not be easily fixed. |
==== STOP ==== | ==== STOP ==== |