Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
vms:ipfire [2015/03/31 19:26] admin [Start the VM] |
vms:ipfire [2015/03/31 19:28] (current) admin [Start the VM] |
||
|---|---|---|---|
| Line 125: | Line 125: | ||
| the -c tells xl to connect you to the console immediately. You can watch as the housekeeping is done (mainly, enlarging the / partition), then you will see the reboot message. When you are back at the DOM0 prompt, reconnect with | the -c tells xl to connect you to the console immediately. You can watch as the housekeeping is done (mainly, enlarging the / partition), then you will see the reboot message. When you are back at the DOM0 prompt, reconnect with | ||
| + | <code> | ||
| + | > xl console ipfire | ||
| + | </code> | ||
| - | xl console ipfire | + | Then configure the router. Remember, if you are connected over a terminal window on your workstation (likely via ssh), the size of the window should be as close as possible to 80 char x 24 lines. This is an ongoing issue with the scon install, and one that can not be easily fixed. |
| - | + | ||
| - | and configure your router. Remember, if you are connected over a terminal window on your workstation (likely via ssh), the size of the window should be as close as possible to 80 char x 24 lines. This is an ongoing issue with the scon install, and one that can not be easily fixed. | + | |
| ==== STOP ==== | ==== STOP ==== | ||
